Suzuki Intruder VZR1800 Service Manual page 120

3-68 ENGINE
• Hold the balancer driven gear No. 2 3 with the special tool.
% 09920-53740: Clutch sleeve hub holder
• Turn the balancer driven gear No. 1 4 and align the holes.
• Apply THREAD LOCK SUPER to the bolts (5, 6).
* 99000-32030: THREAD LOCK SUPER "1303"
• Tighten the bolts (5, 6) to the specified torque.
# Balancer driven gear No. 1 bolt 5:
Balancer driven gear No. 2 bolt 6:
• Set the balancer shaft so that its slit A is aligned with the
punch mark B on the balancer driven gear.
• Install the balancer driven gear assembly onto the balancer
shaft with the special tool.
% 09913-70210: Bearing installer set (25 mm)
or equivalent
10 N·m (1.0 kgf-m, 7.0 lb-ft)
25 N·m (2.5 kgf-m, 18.0 lb-ft)