Suzuki Intruder VZR1800 Service Manual page 138

3-86 ENGINE
• Apply engine coolant to the O-ring.
"
Use a new O-ring to prevent engine coolant leakage.
• Install the water inlet pipe 1.
• Tighten the water inlet pipe mounting bolts.
OIL PRESSURE SWITCH
• Apply SUZUKI BOND to the thread part of oil pressure switch
and tighten oil pressure switch to the specified torque.
, 99000-31110: SUZUKI BOND "1215" or equivalent
# Oil pressure switch: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
NOTE:
Be careful not to apply SUZUKI BOND to the hole of thread end.
OIL COOLER
• Apply engine oil to the O-ring.
"
Use the new O-ring to prevent oil pressure leak.
NOTE:
When install the oil cooler, fit the convex part A of the lower
crankcase onto the concave part B of the oil cooler.
• Install the oil cooler to the crankcase and tighten the bolt to
the specified torque.
# Oil cooler union bolt: 70 N·m (7.0 kgf-m, 50.5 lb-ft)