Suzuki Intruder VZR1800 Service Manual page 347

• Apply SUZUKI SUPER GREASE "A" to the impeller shaft
and O-ring.
!
Use the new O-ring to prevent engine oil leakage.
* 99000-25010: SUZUKI SUPER GREASE "A"
• Install the impeller shaft 1, washer 2 and O-ring 3 to the
water pump body.
• Install the rubber seal 4 into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side B of mechanical seal ring faces the rub-
ber seal.
• Install the washer 5 and seal washer 6 onto the impeller
securing bolt 7.
NOTE:
The metal side C of seal washer and the curved side D of
washer face the impeller securing bolt head.
• Install the impeller 8 and its securing bolt onto the shaft.
• Tighten the impeller securing bolt to the specified torque.
( Impeller securing bolt: 8 N·m (0.8 kgf-m, 6.0 lb-ft)
NOTE:
Before installing the impeller securing bolt, apply a small quan-
tity of the THREAD LOCK to it.
+ 99000-32050: THREAD LOCK "1342" or equivalent
COOLING AND LUBRICATION SYSTEM
or equivalent
8-17