Suzuki Intruder VZR1800 Service Manual page 445

10-20 ELECTRICAL SYSTEM
GEAR POSITION SWITCH
• Remove the right frame side cover. (!9-5)
• Disconnect the gear position switch coupler and check the
continuity between Blue and Black/White with the transmis-
sion in "NEUTRAL".
" 09900-25008: Multi-circuit tester set
- Tester knob indication: Continuity test (.)
ON (Neutral)
OFF (Except neutral)
#
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch to "ON" position and side-stand to
upright position.
• Measure the voltage between Pink and Black/White lead
wires using the multi-circuit tester when shifting the gearshift
lever from low to top.
" 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
' Tester knob indication: Voltage (&)
$ Gear position switch voltage: 0.6 V and more
* Low to top gear position (Pink + – B/W -)
* Except neutral position
#
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
Blue Black/White
(Pink + – B/W -)
V