Suzuki Intruder VZR1800 Service Manual page 396

CUSHION ROD BEARING
• Install the bearings into the cushion rod with the special tool.
% 09913-70210: Bearing installer set (35 mm)
• Press the bearing at 1.0 mm (0.04 in) depth from the cushion
rod edge. (!9-46)
CUSHION LEVER BEARING
• Press the cushion lever upper bearings into the cushion lever
with the special tool and suitable size socket wrench 1.
% 09924-84521: Bearing installer set
NOTE:
* When installing the bearing, stamped mark on the bearing
must face outside.
* Press the bushing at 4.5 mm (0.17 in) depth from the cushion
lever edge. (!9-46)
• Press the cushion lever lower bearings with the special tool.
% 09924-84521: Bearing installer set
NOTE:
* When installing the bearing, stamped mark on the bearing
must face outside.
* Press the bushing at 1.0 mm (0.04 in) depth from the cushion
lever edge. (!9-46)
• Install the dust seals into the cushion lever with the special
tool.
% 09913-70210: Bearing installer set (35 mm)
NOTE:
Apply SUZUKI SUPER GREASE "A" to the dust seals.
' 99000-25010: SUZUKI SUPER GREASE "A"
SWINGARM BEARING
• Press the swingarm pivot bearings into the frame with the
special tool.
% 09941-34513: Steering race installer
NOTE:
When installing the bearing, stamped mark on the bearing must
face outside.
or equivalent
CHASSIS 9-47