Suzuki Intruder VZR1800 Service Manual page 369

9-20 CHASSIS
• Tighten the damper rod bolt to the specified torque with the
special tool.
% 09940-30221: Front fork assembling tool
# Damper rod bolt: 40 N·m (4.0 kgf-m, 29.0 lb-ft)
FORK OIL
• Place the front fork vertically without spring.
• Compress it fully.
• Pour specified front fork oil up to the top level of the outer
tube.
+ 99000-99044-L01: SUZUKI FORK OIL L01
• Move the inner rod slowly with the special tool ten times and
more until no more bubbles come out from the oil.
% 09940-52841: Inner rod holder
NOTE:
Refill front fork oil up to the top of the outer tube so that bubbles
are visible while bleeding air.
• Refill specified front fork oil up to the top level of the outer
tube again. Move the outer tube up and down several strokes
until no more bubbles come out from the oil.
• Keep the front fork vertically and wait 5 – 6 minutes.
NOTE:
* Always keep oil level over the cartridge top end, or air may
enter the cartridge during this procedure.
* Take extreme care so as to pump out air completely.
• Hold the front fork vertically and adjust fork oil level with the
special tool.
NOTE:
When adjusting the fork oil level, compress the outer tube fully
without the fork spring.
& Fork oil level: 133 mm (5.2 in)
% 09943-74111: Front fork oil level gauge
or an equivalent