8-10
COOLING AND LUBRICATION SYSTEM
If the resistance is noted to show infinity or too much different
resistance value, replace the ECT sensor with a new one.
!
* Take special care when handling the ECT sensor. It
may cause damage if it gets a sharp impact.
* Do not contact the ECT sensor and the column ther-
mometer with a pan.
INSTALLATION
• Install the new sealing washer 1.
• Tighten the ECT sensor 2 to the specified torque.
( ECT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
!
* Replace the removed sealing washer 1 with a new
one.
* Take special care when handling the ECT sensor. It
may cause damage if it gets a sharp impact.
• Install the rear intake pipe and thermostat assembly.
(#3-112)
• Install the air cleaner chamber and throttle body. (#6-21)
• Pour engine coolant. (#2-21)