INSTALLATION
Remount the swingarm and shock absorber in the reverse order
of disassembly and removal, and pay attention to the following
points.
CUSHION ROD AND CUSHION LEVER
• Install the cushion rods 1 and cushion lever 2 onto the swin-
garm temporarily.
SWINGARM
• Before installing the swingarm, install the boot and the univer-
sal joint.
NOTE:
Make sure that the "UP" mark A on the boot faces to up.
• Tighten the swingarm pivot shaft to the specified torque with
the special tool.
% 09944-28320: Hexagon socket
# Swingarm pivot shaft: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
NOTE:
After tightening the swingarm pivot shaft, be sure to check the
swingarm operation.
CHASSIS
9-49