Suzuki Intruder VZR1800 Service Manual page 143

FRONT CAM DRIVE IDLE GEAR/SPROCKET
• Turn the crankshaft counterclockwise with the box wrench
and align "R I T" line A on the crankshaft with the index
marks B of the upper crankcase hole.
"
To adjust the camshaft timing correctly, be sure to
align "R I T" line A with the index marks B and hold
this position when installing the cam drive idle
gears/sprockets, front and rear.
• Install the front cam chain tensioner No. 1 assy 1.
• Apply a small quantity of THREAD LOCK SUPER to the bolt
and tighten its to the specified torque.
* 99000-32030: THREAD LOCK SUPER "1303"
# Front chain tensioner No. 1 bolt:
• Engage the cam chain No. 1 onto the cam drive idler sprocket
and install it to the upper crankcase.
• Align the groove A on the cam idler sprocket with the
embossed line B on the upper crankcase. (!3-94)
• Apply SUZUKI MOLY PASTE to the idler shaft 2 and install
the idler shaft.
( MOLYBDENUM OIL SOLUTION
or equivalent
18 N·m (1.8 kgf-m, 13.0 lb-ft)
ENGINE 3-91