Starter Torque Limiter; Generator Cover - Suzuki Intruder VZR1800 Service Manual

3-50 ENGINE

STARTER TORQUE LIMITER

STARTER TORQUE LIMITER INSPECTION
"
* Do not attempt to disassemble the starter torque lim-
iter.
* The starter torque limiter is available only as an
assembly.
• Check the slip torque with the special tools.
$ Slip torque
Standard: 31 – 51 N·m (3.1 – 5.1 kgf-m, 22.5 – 37.0 lb-ft)
% 09930-73170: Starter torque limiter holder
09930-73180: Starter torque limiter socket
• Set the starter torque limiter to the special tools and vise as
shown.
• If the slip torque is not within the specification, replace the
starter torque limiter with a new one.

GENERATOR COVER

GENERATOR INSPECTION (!10-10)
REASSEMBLY
• Apply a small quantity of THREAD LOCK to the startor bolt.
• Tighten the generator stator bolts 1, clamp bolt 2 and CKP
sensor bolts 3.
& 99000-32050: THREAD LOCK "1342" or equivalent
# Generator stator bolt 1: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CKP sensor bolt 3: 6.5 N·m (0.65 kgf-m, 4.5 lb-ft)
NOTE:
Be sure to install the grommet A to the generator cover.
BEARING INSPECTION
• Inspect the starter motor shaft bearing for abnormal noise and
smooth rotation while they are in the generator cover.
• Replace the bearing if there is anything unusual.
BEARING REMOVAL
• Remove the snap ring 1 and bearing 2.