Suzuki Intruder VZR1800 Service Manual page 461

10-36 ELECTRICAL SYSTEM
FUEL LEVEL METER INSPECTION
• Lift and support the fuel tank. (!6-3)
• Disconnect the fuel pump lead wire coupler 1.
• Connect variable resistor between the Light green and Black
lead wires at the wire harness.
• Turn the ignition switch "ON" position and wait for approx. 40
seconds.
Check the display of fuel meter as shown below, If any abnor-
mality is found, replace the combination meter with a new one.
NOTE:
Side-stand is "ON" (side-stand up) position when inspecting it.
More than 190 Ω
Resistance
Thermistor
Fuel level meter
E
Fuel indicator light ON
FUEL LEVEL GAUGE INSPECTION
• Remove the fuel level gauge assembly.
(!6-8)
• Measure the resistance at each fuel level gauge float position.
If the resistance is incorrect, replace the fuel level gauge with
a new one.
Float position
33.7 mm (1.33 in)
54.5 mm (6.67 in)
" 09900-25008: Multi-circuit tester set
( Tester knob indication: Resistance (Ω)
More than 190 Ω
ON
OFF
F E F
Flicker
Resistance
Approx. 10 Ω
Approx. 216 Ω
121 – 190 Ω 70 – 121 Ω
OFF
OFF
– ON – ON
E F E
OFF OFF
Less than 17 Ω
17 – 70 Ω
OFF
OFF
– ON
– ON
E
E F
F
OFF OFF
F
33.7 mm 33.7 mm
(1.33 in) (1.33 in)
54.5 mm 54.5 mm
(2.15 in) (2.15 in)