Table of Contents
Advertisement
Status Messages,
No. Text
529 Calibration stopped because
no raw measurement values
were found.
530 Calibration stopped because
the pressure switch did not
detect any calibration gas.
531 Automatic validation started.
532 Automatic validation ended.
533 Automatic validation externally
interrupted.
534 Automatic validation in
progress.
535 Automatic validation
successful for:
536 Automatic validation out of
limits for:
537 Automatic validation out of
limits for:
User-Configured Messages
800 An external error occurred
during:
801 A user-defined error occurred
during:
802 A user-defined maintenance
requirement occurred during:
803 A user-defined maintenance
mode event occurred during:
Miscellaneous Messages
1000 This function block has an
error:
1001 Condensate penetration.
1002 Flow rate excessive at this
point.
1003 Flow rate inadequate at this
point.
10-16
continued
O E M F Reaction / Remark
x
x
x
x
For information
For information
For information
x For information, not logged
x
x x
These Message Generator function block default texts
are supplemented with the text prepared during function
block configuration.
x x
x
x
x x
Supplemented with a reference to the function block type.
Overall message for guiding reaction to condensate
penetration; not logged
x x
Currently not used
x x
Currently not used
Chapter 10: Status Messages, Troubleshooting
Continued on next page
42/24-10 EN Rev. 9
Advertisement
Table of Contents
