Table of Contents
Advertisement
Status Messages,
No. Text
360 Filter wheel 1 cannot be
initialized.
361 Filter wheel 2 cannot be
initialized.
362 The calibration filter wheel
cannot be initialized.
363 The Limas analyzer board
cannot be initialized.
364 A new lamp is installed and
the amplifiers settings are
optimized.
365 The LIMAS amplifiers settings
are optimized.
LS25
366 The LS25 analyzer has an
error.
367 The LS25 analyzer has a
maintenance request.
368 The LS25 analyzer starts
measurement.
369 LS25 analyzer detector error # x x
370 The beam transmission
exceeds the permissible
range.
371 The temperature input signal
exceeds the permissible
range.
372 The pressure input signal
exceeds the permissible
range.
373 The flow sensor signal
exceeds the permissible
range.
374 The detector signal is too low
for measurement.
375 The input current loop
(4-20mA) has an error.
376 This LS25 module is under
maintenance.
Uras
378 Chopper wheel jammed.
379 Chopper wheel speed not OK. x x
380 IR radiator or electronics
faulty.
381 High voltage at preamplifier
faulty.
42/24-10 EN Rev. 9
continued
O E M F Reaction / Remark
x x
Notify service.
x x
Notify service.
x x
Notify service.
x x
Notify service.
For information
For information
x x
x
x
x x
x
Low transmission
x
T out of range
x
P out of range
x
x x
Laser line-up error
x x
T-read error, P-read error
x
x Communication with service software via RS232. No
measured values are transferred.
x x
Notify service.
Notify service.
x x
Notify service.
x x
Notify service.
Chapter 10: Status Messages, Troubleshooting
Continued on next page
10-13
Advertisement
Table of Contents
