Config Igmp_Snooping - D-Link DGS-1210/ME series Reference Manual

Command
access_authentication
ports
show igmp
access_authentication
ports
enable igmp_snooping
disable igmp_snooping
show igmp_snooping
show igmp_snooping
group
show igmp_snooping
forwarding
show igmp_snooping
host
show igmp_snooping
multicast_vlan
show igmp_snooping
multicast_vlan_group
show router_port
Each command is listed in detail, as follows:

config igmp_snooping

Purpose
Syntax
Description
Parameters
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
[<portlist> | all]
{multicast_vlan | forward_mcrouter_only}
{multicast_vlan | forward_mcrouter_only}
{vlan <vlan_name 32> | vlanid <vidlist> | multicast_vlan <vlan_name 32> |
multicast_vlan_group <vlan_name 32>}
[vlan <vlan_name 32> | vlanid <vidlist>] <ipaddr> {data_driven}
{vlan <vlan_name 32> | vlanid <vidlist>}
{ports <portlist> | group <ipaddr> | vlan <vlan_name 32> | vlanid <vidlist>}
{<vlan_name 32>}
{<vlan_name 32>}
{vlan <vlan_name 32> | vlanid <vidlist> | static | dynamic | forbidden}
To configure IGMP snooping on the Switch.
config igmp_snooping [vlan_name <string 32> | vlanid <vidlist>
| all] [host_timeout <sec 130-153025> | router_timeout <sec 60-
600> | leave_timer <sec 1-25> | fast_leave [enable | disable] | |
report_suppression [enable | disable] | state [enable | disable]]
The config igmp_snooping command configures IGMP snooping
on the Switch.
vlan_name <string 32> − The name of the VLAN for which IGMP
snooping is to be configured.
vlanid <vidlist> − The VLAN id for which IGMP snooping is to be
configured.
all − Specifies all VLAN for which IGMP snooping is to be
configured.
host_timeout <sec 130-153025> − Specifies the maximum amount
of time a host can be a member of a multicast group without the
Switch receiving a host membership report. The default is 260
seconds.
router_timeout <sec 60-600> − Specifies the maximum amount of
time a route can be a member of a multicast group without the
Switch receiving a host membership report.
leave_timer <sec 1-25> − Leave timer. The default is 10 seconds.
285