Enable Password Encryption - D-Link DGS-1210/ME series Reference Manual

Command
reboot
reset
reload config config_id
logout
ping
ping6
traceroute
traceroute6
show cpu port
reset cpu port
enable telnet
disable telnet
config time_range
show time_range
show tech support
clear tech support
Each command is listed in detail, as follows:

enable password encryption

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable password encryption on the Switch:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
{[config | system | account | password {<user_name 15>}]} {force_agree}
<value 1-2>
<ipaddr> {times <value 1-255> | timeout <sec 1-99> | size <short 0-2080>}
<ipv6_addr> {frequency <sec 0-86400> | size <value 1-1522> | source_ip
<ipv6_addr> | timeout <sec 1-99> | times <value 1-255>}
<ip_addr> {[max-ttl <short 1-99> | min-ttl <short 1-99>}
<ipv6_addr> {[max-ttl <short 1-99> | min-ttl <short 1-99>]}
<range_name 20> [[hours start_time <start_time 32> end_time <end_time 32>
weekdays <daylist 32> date from_day year <start_year 2009-2037> month
<start_mth 1-12> date <start_date 1-31> to_day year <end_year 2009-2037>
month <end_mth 1-12> date <end_date 1-31>] | delete]
{<range_name 20>}
Used to enable password encryption on a user account.
enable password encryption
The user account configuration information will be stored in the
configuration file, and can be applied to the system at a time in the
future. If the password encryption is enabled, the password will be in
encrypted form. If password encryption is disabled and the user
specifies the password in encrypted form, or if the password has
been converted to encrypted form by the last enabled password
encryption command, the password will still be in encrypted form. It
can not revert back to plain text.
None.
Only Administrator level users can issue this command.
DGS-1210-28P/ME:5# enable password encryption
Command: enable password encryption
11