Disable Qinq; Show Qinq - D-Link DGS-1210/ME series Reference Manual

disable qinq

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable Q-in-Q:

show qinq

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the Q-in-Q status for ports 1 to 2:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
DGS-1210-28P/ME:5#
To disable the Q-in-Q mode.
disable qinq
The disable qinq command creates a used to disable the Q-in-Q
mode.
All dynamically learned L2 address will be cleared. All dynamically
registered VLAN entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the Switch, firstly enable GVRP
manually. All existing SP-VLANs will run as static 1Q VLANs. The
default setting of Q-in-Q is disabled.
None.
Only administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# disable qinq
Command: disable qinq
Success.
DGS-1210-28P/ME:5#
To show global Q-in-Q and port Q-in-Q mode status.
show qinq {ports [<portlist> | inner_tpid]}
The show qinq command is used to show the global Q-in-Q status,
including: port role in Q-in-Q mode and port outer TPID.
<portlist> - Specifies a range of ports to be displayed.
If no parameter is specified, the system will display all Q-in-Q port
information.
Inner_tpid – Specifies the inner tpid to be showed .
None.
DGS-1210-28P/ME:5# show qinq ports 1-2
Command: show qinq ports 1-2
Port ID: 1
---------------------------------------------------------
Role:
Miss Drop:
Outer Tpid:
UNI
Disabled
0x8100
255