Dlink Discover Protocol Commands; Config Ddp; Config Ddp Report - D-Link DGS-1210/ME series Reference Manual

DLINK DISCOVER PROTOCOL COMMANDS

The D-Link Discover Protocol commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config ddp

config ddp report

config ddp report timer
Each command is listed in detail, as follows:
config ddp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the D-Link discover protocol function:
DGS-1210-28P/ME:5# config ddp enable
Command: config ddp enable
DGS-1210-28P/ME:5#
config ddp report
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the D-Link discover protocol packet report function:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
[enable | diasble]
[enable | diasble]
<integer 1-120>
To enable or disable the D-Link discover protocol function.
config ddp [enable | diasble]
The config ddp command is used to enable or disable the D-Link
discover protocol function.
[enable | disable] – Specifies to enable or disable the D-Link
discover protocol function.
Only administrator or operate-level users can issue this command.
To enable or disable the D-Link discover protocol packet report
function.
config ddp report [enable | diasble]
The config ddp report command is used to enable or disable the D-
Link discover protocol packet report function.
[enable | disable] – Specifies to enable or disable the D-Link
discover protocol packet report function.
Only administrator or operate-level users can issue this command.
45
8