Igmp Snooping Commands; Config Igmp_Snooping - D-Link DGS-3100 SERIES Cli Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config igmp_snooping

config igmp_snooping
querier
config router_port
config
router_port_forbidden
enable igmp_snooping
disable igmp_snooping
show igmp_snooping
show igmp_snooping
group
show igmp_snooping
forwarding
show router_port
Each command is listed in detail, as follows:
config igmp_snooping
Purpose
Syntax
Description
Parameters

IGMP SNOOPING COMMANDS

Parameter
[<vlan_name 32> | all] {host_timeout <sec 60-16711450> | router_timeout <sec
1-16711450> | leave_timer <sec 0-16711450> | state [enable | disable]}
[vlan <vlan_name 32> | all] state [enable | disable] {querier_version [IGMPv2 |
IGMPv3]}
<vlan_name 32> [add | delete] <portlist>
<vlan_name 32> [add | delete] <portlist>
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32> | static | dynamic | forbidden}
To configure IGMP snooping on the Switch.
config igmp_snooping [<vlan_name 32> | all] {host_timeout
<sec 60-16711450> | router_timeout <sec 1-16711450> |
leave_timer <sec 0-16711450> | state [enable | disable]}
The config igmp_snooping command configures IGMP snooping
on the Switch.
<vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be configured.
all – Specifies that IGMP snooping is to be configured for all VLANs
on the Switch.
host_timeout <sec 60-16711450> − Specifies the maximum amount
of time a host can be a member of a multicast group without the
Switch receiving a host membership report. The default is 260
seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount
of time a route can be a member of a multicast group without the
Switch receiving a host membership report. The default is 300
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
17
114