Config Wac Switch_Http_Port; Config Wac Virtual_Ip - D-Link DGS-1210/ME series Reference Manual

DGS-1210-28P/ME:5#
To configure the WAC port aging time:
DGS-1210-28P/ME:5# config wac ports 8-12 aging_time 200
Command: config wac ports 8-12 aging_time 200
Success.
DGS-1210-28P/ME:5#

config wac switch_http_port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a TCP port which the WAC switch listens to:
DGS-1210-28P/ME:5# config wac switch_http_port 8888 https
Command: config wac switch_http_port 8888 https
Success.
DGS-1210-28P/ME:5#

config wac virtual_ip

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To configure the TCP port which the WAC switch listens to.
config wac switch_http_port <tcp_port_number 1-65535>
{https}
The config wac switch_http_port command is used to configure
the TCP port which the WAC switch listens to. The TCP port for
HTTP or HTTPs is used to identify the HTTP or HTTPs packets that
will be trapped to CPU for authentication processing, or to access
the login page. If not specified, the default port number for HTTP is
80, and the default port number for HTTPS is 443. If no protocol is
specified, the protocol is HTTP.
[tcp_port_number <1-65535>] –Specifies a TCP port which the WAC
switch listens to and uses to finish the authenticating process.
https - Specifies that WAC runs HTTPS protocol on this TCP port.
Only administrator or operator-level users can issue this command.
To configure the WAC virtual IP address.
config wac virtual_ip [<ipaddr> | <ipv6addr>]
The config wac virtual_ip command is is used to configure the
WAC virtual IP address.
[<ipaddr> | <ipv6addr>] – Specifies the IP or IPv6 address of the
virtual IP.
Only administrator or operator-level users can issue this command.
249