Arp Commands; Create Arpspoofing - D-Link DGS-1210/ME series Reference Manual

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command

create ArpSpoofing

show ArpSpoofing
delete ArpSpoofing
config arp_aging time
clear arptable
create arpentry
config arpentry
delete arpentry
show arpentry
show arpentry
aging_time
Each command is listed in detail, as follows:
create ArpSpoofing
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
ip_address <ipaddr> mac_address <macaddr> [<portlist> | all]
ip_address <ipaddr>
<value 0-65535 >
<ipaddr> <macaddr>
<ipaddr> <macaddr>
[<ipaddr> | all]
{information | interface_name {system} | ip_address <ipaddr> | mac_address
<macaddr> | summary}
To create the on the Switch.
create ArpSpoofing ip_address <ipaddr> mac_address
<macaddr> [<portlist> | all]
The create ArpSpoofing command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch's ARP
table, without being accessed, before it is dropped from the table.
ip_address <ipaddr> − Specifies the IP address of the end node or
station.
mac_address<macaddr> − Specifies the MAC address
corresponding to the IP address above.
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
configured for the ARP snooping.
Only Administrator-level users can issue this command.

ARP COMMANDS

352
47