Config Bootrom Password; Enable Clipaging - D-Link DGS-1210/ME series Reference Manual

Restrictions
Example usage:
To configure the serial port baud rate:

config bootrom password

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the boot ROM password:

enable clipaging

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
5_minutes − The console will log out the current user if there is no
user input for 5 minutes.
10_minutes − The console will log out the current user if there is no
user input for 10 minutes.
15_minutes − The console will log out the current user if there is no
user input for 15 minutes.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Please change your baud rate to 115200 for new baud rate !!
Success.
DGS-1210-28P/ME:5#
Used to configure the password when booting ROM.
config bootrom password <string20>
The config bootrom password command is used to configure the
password when booting ROM.
<string 20> - Specifies the password.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# config bootrom password 1234
Command: config bootrom password 1234
Success.
DGS-1210-28P/ME:5#
Used to pause the scrolling of the console screen when a command
displays more than one page.
enable clipaging
The enable clipaging command is used when issuing a command
which causes the console screen to rapidly scroll through several
pages. This command will cause the console to pause at the end of
each page. The default setting is enabled.
None.
Only Administrator or operator-level users can issue this command.
19