Config Arp_Aging Time; Clear Arptable - D-Link DGS-1210/ME series Reference Manual

To delete the ARP spoofing configuration:
DGS-1210-28P/ME:5# create ArpSpoofing ip_address 10.2.1.1
Command: create ArpSpoofing ip_address 10.2.1.1
Success.
DGS-1210-28P/ME:5#

config arp_aging time

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ARP aging time:

clear arptable

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure the age-out timer for ARP table entries on the Switch.
config arp_aging time <value 0-65535>
The config arp_aging time command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch's ARP
table, without being accessed, before it is dropped from the table.
<value 0-65535> – The ARP age-out time, in minutes. The value
may be in the range of 0-65535 minutes, with a default setting of 20
minutes.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-1210-28P/ME:5#
To remove all dynamic ARP table entries.
clear arptable
The clear arptable command is used to remove dynamic ARP table
entries from the Switch's ARP table. Static ARP table entries are not
affected.
None.
Only Administrator or operator-level users can issue this command.
354