Network Management (Snmp) Commands - D-Link DGS-1210/ME series Reference Manual

NETWORK MANAGEMENT (SNMP) COMMANDS

The Switch supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. Users can specify
which version of the SNMP users want to use to monitor and control the Switch. The three versions of SNMP
vary in the level of security provided between the management station and the network device. The following
table lists the security features of the three SNMP versions:
SNMP Version Authentication Method
v1 Community String
v2c Community String
v3 Username
v3 MD5 or SHA
v3 MD5 DGS or SHA DGS
The Network Management commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create snmp user
delete snmp user
show snmp user
create snmp view
delete snmp view
show snmp view
create snmp community
delete snmp community
show snmp community
config snmp engineID
show snmp engineID
enable
community_encryption
disable
community_encryption
show
community_encryption
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Description
Community String is used for authentication - NoAuthNoPriv
Community String is used for authentication - NoAuthNoPriv
Username is used for authentication – NoAuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms – AuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms – AuthPriv. DGS 56-bit encryption is added based
on the CBC-DGS(DGS-56) standard
Parameter
<username 32> <groupname 32> [v1 | v2c | v3 [MD5 <auth_password 32> |
SHA <auth_password 32> | none ] [DES <priv_password 32> | none]]
<username 32> [v1 | v2c | v3]
<view_name 32> <oid 32> <oid_mask 32 view_type [included | excluded]
<view_name 32> <oid 32>
{<view_name 32>}
<community_string 32> [<username 32> | view <view_name 32>] [read_only |
read_write]
<community_string 32>
{<community_string 32>}
<snmp_engineID 64>
77
15