Qos Commands - D-Link DGS-1210/ME series Reference Manual

The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config scheduling
show scheduling
config
bandwidth_control
show
bandwidth_control
config cos
mac_mapping
show cos
mac_mapping
delete cos
mac_mapping
config cos ip_mapping
show cos ip_mapping
delete cos ip_mapping
config cos
ipv6_mapping
show cos
ipv6_mapping
delete cos
ipv6_mapping
config cos
ipv6_tc_mapping
delete cos
ipv6_tc_mapping
show cos
ipv6_tc_mapping
config cos mapping
show cos mapping
config cos
protocol_mapping
show cos
protocol_mapping
delete cos
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
<class_id 0-7> weight <value 1-55>
[<portlist> | all] {rx_rate [no_limit | <value 63-1000000>] | tx_rate [no_limit |
<value 63-1000000>]}
{[<portlist> | all]}
destination_addr <macaddr> class <class_id 0-7>
{destination_addr <macaddr>}
destination_addr <macaddr>
destination_ip <ipaddr> class <class_id 0-7>
{destination_ip <ipaddr>}
destination_ip <ipaddr>
destination_ipv6 <ipv6addr> class <class_id 0-7>
{destination_ipv6 <ipv6addr>}
destination_ipv6 <ipv6addr>
trafficclass <class_id 0-255> class <class_id 0-7>
trafficclass <class_id 0-255>
{trafficclass <class_id 0-255>}
port [<portlist> | all] [802.1p | dscp_tos | none]
{port <portlist>}
protocol <ip_protocol 1-255> class <class_id 0-3
{protocol <ip_protocol 1-255>}
protocol <ip_protocol 1-255>

QOS COMMANDS

187
27