Config Firmware Image_Id - D-Link DGS-1210/ME series Reference Manual

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
#------------------------------------------------------------------------------------------------
# DGS-1210-28P/ME Gigabit Ethernet Switch Configuration
#
#
# Copyright(C) 2010 D-Link Corporation. All rights reserved.
#------------------------------------------------------------------------------------------------
# User Account
disable password encryption
# Basic
config syslogintimeout 5
config vlan_auto_learn vlanid disable
enable web 80
enable clipaging
config command_prompt default
config serial_port baud_rate 9600
config serial_port auto_logout 10_minutes
# Gratuitous Arp
config gratuitous_arp send ipif_status_up disable
config gratuitous_arp send dup_ip_detected disable
config gratuitous_arp learning disable
config gratuitous_arp send periodically interval 0
# Arp Aging Time
config arp_aging time 5
# FDB Aging Time
config fdb aging_time 300
# Telnet Setting
enable telnet 23
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL

config firmware image_id

Purpose
Syntax
Description
Parameters
Firmware: Build 6.11.B037
Used to configure the firmware image id.
config firmware image_id <value 1-2> [boot_up | delete]
The config firmware image_id command is used to configure the
firmware image id.
<value 1-2> - Specify the image id to be configured.
[boot_up | delete] – Specify to boot up or delete the specified image
115