Cpu Protection Commands; Enable Cpu_Protect; Disable Cpu_Protect - D-Link DGS-1210/ME series Reference Manual

The CPU Protection commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable cpu_protect

disable cpu_protect

config cpu_protect
show cpu_protect
Each command is listed in detail, as follows:
enable cpu_protect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the CPU protection function on the switch:
DGS-1210-28P/ME:5# enable cpu_protect
Command: enable cpu_protect
Success.
DGS-1210-28P/ME:5#
disable cpu_protect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the CPU protection function on the switch:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

CPU PROTECTION COMMANDS

Parameter
[arp | bpdu | icmp | igmp | snmp] pps [<value> | no_limit]
To enable the CPU protection function on the Switch.
enable cpu_protect
The enable cpu_protect command is used to enable the CPU
protection function on the Switch.
None.
Only Administrator or operator–level users can issue this command.
To disable the CPU protection function on the Switch.
disable cpu_protect
The disable cpu_protect command is used to disable the CPU
protection function on the Switch.
None.
Only Administrator or operator–level users can issue this command.
140
20 1