Reset - D-Link DGS-1210/ME series Reference Manual

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Model_Name: DGS-1210-28P/ME
Hit any key to stop autoboot: 0
Uncompressing Kernel Image ... OK
Loading Runtime Image ......
Starting kernel ...
MAC Address : 9C-D6-43-60-4F-A4
H/W Version : Rev.A1
F/W Version : 6.11.B037
.............................................................
DGS-1210-28P/ME Gigabit Ethernet Switch
Copyright(C) 2012 D-Link Corporation. All rights reserved.
UserName:
Password:

reset

Purpose
Syntax
Description
Parameters
Command Line Interface
Firmware: Build 6.11.B037
To reset the Switch to the factory default settings.
reset {[config | system | account | password {<user_name
15>}]} {force_agree}
The reset command restores the Switch's configuration to the
default settings assigned from the factory. Execution of the reset
command through the CLI retains the unit's current stack
membership number.
config - If the keyword 'config' is specified, all of the factory default
settings are restored on the Switch including the IP address, user
accounts, and the switch history log. The Switch will not save or
reboot.
system − If the keyword 'system' is specified all of the factory default
settings are restored on the Switch. The Switch will save and reboot
after the settings are changed to default. Rebooting will clear all
entries in the Forwarding Data Base.
account − If the keyword 'account is specified, all of the factory
default account settings are restored on the Switch.
password − If the keyword 'password is specified, all of the factory
default password settings are restored on the Switch.
{force_agree} - When force_agree is specified, the reset command
will be executed immediately without further confirmation.
If no parameter is specified, the Switch's current IP address, user
accounts, and the switch history log are not changed. All other
parameters are restored to the factory default settings. The Switch
25
100%