Dhcp Autoimage Commands; Enable Autoimage; Disable Autoimage - D-Link DGS-1210/ME series Reference Manual

The DHCP Autoimage commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable autoimage

diable autoimage
show autoimage
Each command is listed in detail, as follows:
enable autoimage
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the DHCP automatic image function on the Switch:

disable autoimage

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the DHCP automatic image function on the Switch:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

DHCP AUTOIMAGE COMMANDS

Parameter
To enable the DHCP automatic image function on the Switch.
enable autoimage
The enable autoimage command is used to enable the DHCP
automatic image function on the Switch.
None.
Only Administrator and Operator-level users can issue this
command.
DGS-1210-28P/ME:5# enable autoimage
Command: enable autoimage
Success.
DGS-1210-28P/ME:5#
To disable the DHCP automatic image function on the Switch.
disable autoimage
The disable autoimage command is used to disable the DHCP
automatic image function on the Switch.
None.
Only Administrator and Operator-level users can issue this
command.
DGS-1210-28P/ME:5# disable autoimage
36
5