Config Configuration Config_Id - D-Link DGS-1210/ME series Reference Manual

Description
Parameters
Restrictions
Example usage:

config configuration config_id

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
[<ipaddr> | <ipv6_addr>] <path_filename 64>]]
The upload command uploads the Switch's current settings to a
TFTP server.
firmware_toTFTP − Specifies that the Switch's current firmware are
to be uploaded to the TFTP server.
<ipaddr> − The IPv4 address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
<ipv6_addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − The location of the Switch configuration file on
the TFTP server.
config_id <value 1-2> − Specifies the config id which to be
uploaded.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5#
28me.ros
Command: upload log_toTFTP 1.1.1.23 DGS-1210-28me.ros
01–Jan–2000 01:26:11 %COPY–I–FILECPY: Files Copy – source
URL running–config Destination URL tftp://1.1.1.23/1\running–
config
... ..01–Jan–2000 01:26:16 %COPY–W–TRAP: The copy operation
was completed success fully!
158 bytes copied in 00:00:05 [hh:mm:ss]
DGS-1210-28P/ME:5#
Used to delete the specific firmware or configure the specific
firmware as boot up image.
config configuration config_id <value 1-2> [boot_up | delete]
The config configuration config_id command is used to delete the
specific firmware or configure the specific firmware as boot up
image.
<value 1-2> − Specifies the serial number of the indicated
configuration.
[boot_up | delete] − Specifies the config is boot_up config or delete
the specified configuration.
Only Administrator or operator-level users can issue this command.
DGS-1210-28/ME:5# config configuration config_id 1 boot_up
Command: config configuration config_id 1 boot_up
Success.
DES-1210-52/ME:5#
upload log_toTFTP
113
1.1.1.23 DGS-1210-