Control Techniques unidrive sp Advanced User's Manual page 297

Menus 15 to 17 Parameter Keypad and
SM-Applicat'ns structure display
CTNet easy mode - third cyclic parameter destination node ♣
x.30
Drive types Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Default All drives
Range All drives
Update Rate Not Applicable
CTNet easy mode - third cyclic source parameter ♣
x.31
Drive types Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Default All drives
Range All drives
Update Rate Not Applicable
CTNet easy mode set-up - transfer slot 1 destination parameter ♣
x.32
Drive types Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Default All drives
Range All drives
Update Rate Not Applicable
x.33 CTNet easy mode set-up - transfer slot 2 destination parameter♣
Drive types Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Default All drives
Range All drives
Update Rate Not Applicable
CTNet easy mode set-up - transfer slot 3 destination parameter ♣
x.34
Drive types Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Default All drives
Range All drives
Update Rate Not Applicable
The above parameters are the CTNet Easy Mode set-up parameters. Pr x.26 to Pr x.31 allow 3 parameters to be setup for cyclic transmission to
remote nodes via CTNet. Pr x.32 to Pr x.34 allow the user to specify which parameters should be updated from cyclic data received in slots 1 to 3 on
the local node.
296
Parameter Parameter
x.00 description format
FI DE Txt VM DP ND
0
0 to 25,503
FI DE Txt VM DP ND
0
0 to 9,999
FI DE Txt VM DP ND
0
0,000 to 9,999
FI DE Txt VM DP ND
0
0,000 to 9,999
FI DE Txt VM DP ND
0
0,000 to 9,999
www.controltechniques.com
http://nicontrols.com
Advanced parameter
Macros
descriptions
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Serial comms Electronic
Performance
protocol nameplate
PS
1
PS
1
PS
1
PS
1
PS
1
Unidrive SP Advanced User Guide
Issue Number: 7
Feature look-
up table