Removing And Replacing Structural Parts; Removing The Shipping Brackets Kit - Lenovo Converged HX Series Installation And Service Manual

Step 5. Make sure that the power LED on the compute node control panel is lit continuously, indicating that
the compute node is receiving power and is turned on.
Step 6. If you have other compute nodes to install, do so now.
Important: If an Attention label is on the front panel of the compute node above the power button, read it;
then, remove the label and discard it before turning on the compute node.
If this is the initial installation of the compute node in the chassis, you must configure the compute node
through the Setup utility and install the compute node operating system. See "Updating the compute node
configuration" on page 80 and operating-system documentation for details.
If you have changed the configuration of the compute node or if you are installing a different compute node
from the one that you removed, you must configure the compute node through the Setup utility, and you
might have to install the compute node operating system (see "Using the Setup utility" on page 27).

Removing and replacing structural parts

This section provides information for removing and replacing structural parts in the server.
Replacement of structural parts is your responsibility. If Lenovo installs a structural part at your request, you
will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.

Removing the shipping brackets kit

Use this information to remove the shipping brackets kit from the server.
To remove the shipping brackets kit, complete the following steps.
Step 1. Turn off the server (see "Turning off the server" on page 23 for instructions) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external cables from the
server.
Step 2. Remove the two (one on each side) 10–32 screws from the brackets on the rear of the chassis.
Figure 18. Removing the two 10–32 screws
Step 3. Remove the four (two on each side) M6 screws from the brackets on the rear of the chassis and
remove the shipping brackets.
.
Chapter 5 Removing and replacing server components
83