CHAPTER 4
HP-AM456-9002A Rev 01
Configuring the Array
When the Memory Array is first powered on, all configuration settings are set to
default values. You must change the default settings to communicate with the
Memory Array over your network(s). This chapter explains how to log into the
Memory Array's command line interface (CLI) to change system settings, such
as the hostname, IP address, DNS, and syslog options in the following sections.
•
Memory Array Default Settings
•
Connecting to the CLI
•
Changing the Default System Settings
•
Configuring DHCP Settings
•
Configuring Domain Name System (DNS)
•
Verifying the Ethernet Connection
•
Displaying and Setting System Log (Syslog) Options
•
Formatting the Memory Array
VMA-series Memory Array Installation and Service Guide
on page 58
on page 59
on page 62
on page 65
on page 67
on page 70
on page 74
on page 71
57