Appendix D - CLI Reference
264
set boot-params
Sets the system boot parameters.
Syntax
set boot-params stagger-mem-clear <value>
Where
value
set clock-source
Sets the system clock source. The source can be set to the host computer or
the Memory Array. The system clock only keeps a running count of the number
of seconds that the system has been operational. It doesn't keep an accurate
calendar date and time. If the system is rebooted, then the elapsed time is not
accounted for when the system finishes the reboot process and is again
operational.
Syntax
set clock-source {host | local}
Where:
Sets the clock source to the host computer. This is the
host
default value.
Sets the clock source to the Memory Array.
local
save config
Commits the admin login password and system log service changes to flash or
reverts back to the factory default settings. If the changes are not committed
before the system is rebooted, then the changes are lost and the previous
settings are used.
Syntax
save config
VMA-series Memory Array Installation and Service Guide
Is either enable or disable.
HP-AM456-9002A Rev 01