Table of Contents
Advertisement
Chapter 7 - Linux Drivers
130
At the Command prompt, type
3.
n
Where
specifies to create a new partition.
n
The command displays information similar to the following:
Command (m for help): n
Command action
e
extended
p
primary partition (1-4)
Next, at the Command prompt, create the new partition by typing:
4.
p
Where
creates a primary partition.
p
The command displays information similar to the following:
Command action
e
extended
p
primary partition (1-4)
p
Partition number (1-4): 1
First cylinder (1-16709, default 1):
Using default value 1
Last cylinder or +size or +sizeM or +sizeK (1-16709, default
16709): 8000
•
Specify the partition number if you will be creating more than one
partition on the device, or accept the default value of
Enter key. The default value to set the beginning cylinder to is
can be changed if needed.
•
Specify the size of the block device or accept the default value of the
available memory by pressing the Enter key.
Next, at the Command prompt, write the new partition by typing:
5.
w
Where
writes the partition table to disk and exit.
w
VMA-series Memory Array Installation and Service Guide
to create a new partition:
n
HP-AM456-9002A Rev 01
by pressing the
1
, which
1
Advertisement
Table of Contents
