Vimm Configurations; Vimm Slot Locations; Table 2.2 Vimm Configurations; Table 2.3 Vimm Slot Locations - HP VMA Series Installation And Service Manual

VIMM Configurations

VIMM Slot Locations

HP-AM456-9002A Rev 01
Memory arrays store up to 64, 128, 256, or 512 GB of data per memory
module providing up to 43 TB of raw flash storage per system. The amount of
usable memory in a system is the number of VIMMs used for data storage,
which is four per redundant array of independent disks (RAID) group (up to 64
VIMMs), multiplied by the amount of memory per module, multiplied by the
usable percentage the system is formatted for. For example, in a fully loaded
system with 84 VIMMs, the usable memory is 64 VIMMs multiplied by 128 GB,
multiplied by the usable percentage, such as 87.5%, which is 7.2 TB.
The Memory Array holds up to 84 VIMMs, which operate in the VIMM
configurations listed in the following table.

Table 2.2 VIMM Configurations

VIMMs Active
84 80
42 40
The Memory Array is available in several VIMM configurations.
VIMM slot numbers used for each configuration. Use the information in the table
when adding, removing, or replacing a non-working VIMM to ensure that the
VIMMs are still in their correct positions. See
information on replacing an errored VIMM.

Table 2.3 VIMM Slot Locations

Number of
VIMMs
42 3, 4, 5, 6, 7, 8, 12, 13, 14, 15, 16, 17, 18, 22, 23, 24,
25, 26, 27, 35, 38, 39, 40, 41, 42, 43, 44, 45, 48, 60,
64, 65, 66, 67, 68, 69, 71*, 75*, 76, 78, 79, 80 (See
Figure
84 All slots (0-83)
* Designates a filler slot.
Refer to the following section for a VIMM slot location diagram:
VMA-series Memory Array Installation and Service Guide
Spare
4
2
Replacing VIMMs
Slot Numbers
2.2)
VIMM Configurations
Table 2.3 lists the
on page 113 for
35