HP-AM456-9002A Rev 01
set active
Sets the specified partition in flash to be activated during the next reboot of the
Memory Array.
Syntax
set active {upgrade | factory}
Where:
Sets the upgrade partition in flash to be activated
upgrade
during the next system reboot. The upgrade partition
contains the downloaded upgrade software.
Sets the factory partition in flash to be activated upon
factory
the next system reboot. The factory partition contains
the factory configuration defaults.
set path
Sets the path where the upgrade software is located. After the command is run,
the upgrade software is downloaded to RAM on the main board and then copied
into the upgrade partition of flash.
Syntax
set path <path>
Where:
Sets the path where the upgrade software is located. A
path
valid path format is user@ftp://host/path/
upgrade.img.
show active
Displays the specified partition in flash to be activated during the next reboot of
the Memory Array. Use this command after the
an upgrade procedure.
Syntax
show active
VMA-series Memory Array Installation and Service Guide
Sw-upgrade Context Commands
command during
set active
295