RAID Group Context Commands
HP-AM456-9002A Rev 01
Figure D.13 RAID>Group Context Level
The table below describes the commands available at the RAID Group context
sublevel of the CLI. Access the RAID Group context sublevel through the RAID
context level. See
RAID Context Commands
Table D.15 RAID Group Context Commands
Command
Moves the user into the context level for the RAID group
context maps
mapping. See
context maps
Moves into the context level for the Maps group.
Syntax
context maps
The system prompt changes to the following:
raid group n maps>
Where:
Specifies the RAID group number in the range of 0-15,
n
inclusively.
Example
To move into the Maps context level for RAID group 5, at the RAID context
prompt, type:
context group 5 maps
VMA-series Memory Array Installation and Service Guide
RAID Group Context Commands
on page 251.
Description
Maps Context Commands
on page 255.
253