Cli Context Commands; Set Columns; Table D.12 Cli Context Commands - HP VMA Series Installation And Service Manual

CLI Context Commands

HP-AM456-9002A Rev 01
Figure D.11 CLI Context Level
The table below describes the commands available at the CLI context level of the
CLI.

Table D.12 CLI Context Commands

Command

set columns

set edit-mode
set history-size
set idle-timeout
set lines
set pagination
show columns
show edit-mode
show history-size
show idle-timeout
show lines
show pagination
show session
cancel session
set columns
Sets the number of columns in the display window.
Syntax
set columns <n>
Where:
The number of columns to set the display window to, which is
n
an integer in the range of 80-200.
VMA-series Memory Array Installation and Service Guide
Description
Sets the number of columns in the display window.
Sets the command line edit mode.
Sets the size of the history buffer.
Sets the time, in minutes, before exiting due to user
inactivity.
Sets the number of lines in the display window.
Enables/disables pagination in the display window.
Displays the number of columns in the display
window.
Displays the command line edit mode.
Displays the size of the history buffer.
Displays the time, in minutes, before exiting due to
user inactivity.
Displays the number of lines in the display window.
Displays the pagination mode of the display window.
Shows the oam_cli session.
Cancels the oam_cli session.
CLI Context Commands
245