Install And Configure The Disk Array; Setting The Host Mode For The Disk Array Ports - HP XP128 Configuration Manual

Storageworks disk array xp operating system
Hide thumbs Also See for XP128:
Table of Contents

Advertisement

Install and configure the disk array

Setting the host mode for the disk array ports

Installation
The HP service representative performs these tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing the channel adapters (CHAs) and cabling
• Installing and formatting devices
After these tasks are finished, you will use Command View or LUN
Configuration Manager to complete the remaining tasks listed below. If
you do not have Command View or LUN Configuration Manager, your HP
service representative can perform these tasks for you.
The disk array ports have host modes that must be set depending on the
host you use. After the disk array is installed use LUN Manager in Remote
Web Console XP (shown), Command View XP, or Command View XP
Advanced Edition to set the host mode for each port.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp1024Xp10000Xp12000

Table of Contents