Chapter 4 - Configuring the Array
68
Configuring the DNS Search Domain Name
When in automatic DNS mode and you set the DNS search domain name, you
are pre-provisioning the value. It is not used until you change the DNS mode to
manual. You can configure the DNS search domain name at any time.
To specify the search domain name of the Memory Array:
Log into the CLI via a serial connection or the Ethernet interface (see
1.
Connecting to the CLI
Navigate to the
2.
context chassis controller ethernet 0
Ethernet 0
At the
3.
set dns-search <value>
Where:
Specifies the search domain name.
value
In the following example, the DNS name server IP address and the DNS search
domain values have been pre-provisioned.
chassis controller ethernet 0> show
dhcp
ip-address
netmask
gateway
mac-address
dns-config
dns-nameserver
dns-search
prov-dns-nameserver 10.10.0.55
prov-dns-search
Displaying the DNS Mode and Pre-
provisioned Information
To display the current DNS mode and various pre-provisioned DNS information
on the Memory Array:
Log into the CLI via a serial connection or the Ethernet interface (see
1.
Connecting to the CLI
Navigate to the
2.
context chassis controller ethernet 0
VMA-series Memory Array Installation and Service Guide
on page 59).
Ethernet 0
context level. At the root prompt, type:
context prompt, type:
enabled
10.10.0.126
255.255.255.0
10.10.0.1
00:1B:97:00:00:06
automatic
10.10.0.2
violintech.net
hi-octane-prod.net
on page 59).
Ethernet 0
context level. At the root prompt, type:
HP-AM456-9002A Rev 01