Exit; Format - HP VMA Series Installation And Service Manual

HP-AM456-9002A Rev 01
Where:
context_level
The available commands and sublevels are different in each context level.

exit

Exits the CLI.
Syntax
exit

format

Configures the system for a specific percentage of usable flash capacity.
Use this command only on a flash-based Memory Arrays.
Note:
The format command will be rejected if there are any open files
Note:
accessing the memory array storage device (/dev/vtmsa). Close any open
files or unmount any mounted filesystems using the storage device. To unmount
the file system use the umount Linux command (e.g., umount /dev/vtmsa).
Syntax
format flash-capacity [
VMA-series Memory Array Installation and Service Guide
Specifies the context level to navigate to. Valid
values are:
• chassis (See Chassis Context Commands
221.)
• cli (See CLI Context Commands
• raid (See RAID Context Commands
• system (See System Context Commands
257.)
]
<value>
General Commands
on page
on page 245.)
on page 251.)
on page
215