Maps Context Commands; Show; Table D.16 Maps Context Commands - HP VMA Series Installation And Service Manual

Maps Context Commands

HP-AM456-9002A Rev 01
Figure D.14 RAID>Group>Maps Context Level
The table below describes the commands available at the Maps context sublevel
of the CLI. Access the Maps context sublevel through the RAID Group context
level. See RAID Group Context Commands

Table D.16 Maps Context Commands

Command
Displays information about the VIMMs in the specified RAID

show

group.
show
Displays the VIMM mapping for the specified RAID group. Four VIMMs in a RAID
group contain data and one contains parity information. Each RAID group can
tolerate a single VIMM failure with no loss of data.
Syntax
show
Example
To display the VIMM mapping information for RAID group 4, at the Maps context
prompt, type:
show
The command displays information similar to the following:
raid group 4 maps> show
group-number
id
state
VMA-series Memory Array Installation and Service Guide
on page 253.
Description
4
19,46,35,73,56
data,data,data,data,data
Maps Context Commands
255