Appendix D - CLI Reference
266
set name
Sets the hostname of the system. When setting the system's name, use only
alphanumeric characters and the hyphen.
Syntax
set name <name>
Where:
name
Use the
save config
show boot-params
Displays the system boot parameters.
Syntax
show boot-params stagger-mem-clear
The command displays information similar to the following:.
system> show boot-params stagger-mem-clear
stagger-mem-clear
show clock
Displays the current time and date of a Memory Array.
Syntax
show clock
The command displays information similar to the following:
system> show clock
clock
VMA-series Memory Array Installation and Service Guide
Specifies the new name for the system.
command to save the changes across system reboots.
enabled
2007-09-24T23:59:58
HP-AM456-9002A Rev 01