Appendix D - CLI Reference
Controller Context Commands
236
Figure D.7 Chassis>Controller Context Commands
The table below describes the commands available at the Controller context
sublevel of the CLI.
Table D.8 Controller Context Commands
Command
context ethernet 0
set serial-speed
show serial-speed
set serial-speed
Sets the speed of the serial port to either 9600 or 115200.
After the changing the serial-speed setting, reboot the Memory Array.
Syntax
set serial-speed {9600 | 115200}
show serial-speed
Shows the speed of the serial port at either 9600 or 115200.
VMA-series Memory Array Installation and Service Guide
Description
Moves the user to the Ethernet 0 context level.
See
Ethernet 0 Context Commands
238.
Sets the speed of the serial port.
Shows the speed of the serial port.
on page
HP-AM456-9002A Rev 01