Table of Contents
Advertisement
HP-AM456-9002A Rev 01
Figure 3.2 Installing the Memory Array into a Rack
To install the Memory Array into a 19" equipment rack:
Remove the Memory Array from the shipping packaging and remove all
1.
packing materials. Visually inspect the system for any shipping damage and,
if any damage is detected, contact HP Customer Support for replacement
parts.
Install the toolless mounting rails at the appropriate height in your
2.
equipment rack. Orient the rails so they slide out to the front of the rack.
Fully extend the rails until they lock into place. Position the Memory Array
3.
above the rails and slide the buttons at the rear sides of the chassis into the
rear slots on the rails.
Slip the remaining sets of buttons into the remaining cutouts in the rails.
4.
Push the whole assembly back into the equipment rack and secure the rack
mounting brackets to the front of the equipment rack with the thumb
screws located on the front mounting brackets, as shown in
Installing the Cable Management Arm
Install the optional cable management arm at the rear of the chassis. The arm
consists of a mounting bracket and cable holder and keeps the cables from
becoming entangled when the system is fully extended from the equipment rack.
The cables are routed along the length of the arm and held in place with cable
ties. The cable management arm is not installed prior to shipping.
VMA-series Memory Array Installation and Service Guide
Rack-Mounting the Chassis
Figure
3.2.
43
Advertisement
Table of Contents
