Table of Contents
Advertisement
HP-AM456-9002A Rev 01
Syntax
set admin <password>
You will be prompted to enter a new password. If the new password meets the
requirements you will be prompted to re-enter the same password. A message
appears indicating that the password has been changed.
The command displays information similar to the following if the new password
does not meet the requirements.
system> set admin foobar
Changing password for admin
Enter the new password (minimum of 6, maximum of 12 characters)
Please use a combination of upper and lower case letters and
numbers.
Enter new password:
Bad password: too simple.
passwd: The password for admin is unchanged.
The password remains unchanged if the new one does not meet the
requirements. You cannot reset the password back to the default password for
the admin user.
Use the
save config
set clock
Sets the system date and time.
Syntax
set clock <yyyy-mm-dd>T<hh:mm:ss>
Where:
yyyy
mm
dd
T
hh
mm
ss
VMA-series Memory Array Installation and Service Guide
command to save the changes across system reboots.
The 4-digit year.
The 2-digit month. Valid values are 01 to 12.
The 2-digit day. Valid values are 01 to 31.
The delineator between the date and the time.
The 2 digit hour. Valid values are 00 to 23.
The 2-digit minutes. Valid values are 00 to 59.
The 2-digit seconds. Valid values are 00 to 59.
System Context Commands
263
Advertisement
Table of Contents
