HP-AM456-9002A Rev 01
Syntax
set dhcp {enabled | disabled}
Where:
enabled
disabled
Use the
save config
set ip-address
Manually sets the IP address of the system.
Syntax
set ip-address <ipaddr>[:<netmask>[:<gateway>]]
Where:
Specifies the system's new IP address.
ipaddr
Optional. Specifies the system's new netmask.
netmask
Optional. Specifies the system's new gateway address.
gateway
Use the
save config
clear ip-address
Clears the provisioned ip/netmask/gateway to use when DHCP is disabled.
Syntax
clear ip-address
Use the
save config
set dns-config
Sets the current DNS configuration type of the system when DHCP has been
enabled. Set the DNS configuration type either manually or automatically.
VMA-series Memory Array Installation and Service Guide
Enables using DHCP to automatically set the system's
IP address.
Disables using DHCP to automatically set the
system's IP address.
command to save the changes across system reboots.
command to save the changes across system reboots.
command to save the changes across system reboots.
Ethernet 0 Context Commands
239