Testing the LEDs
HP-AM456-9002A Rev 01
Perform functional tests on the LEDs associated with the VIMM slots and the
system LEDs located on the front and rear of the Memory Array.
Displaying the Status of the System LEDs
Log into the Memory Array.
1.
System
Navigate to the
2.
context system
At the context prompt, type:
3.
show led-state
The command displays information similar to the following:.
system> show led-state
power-a
power-b
status
alarm
Testing the System LEDs
This test lights all system and VIMM LEDs for two seconds, turns them off for
two seconds, then reverts the LEDs to their previous states. The exceptions to
Power A
this are the
and
of power.
To test the system LEDs:
Log into the Memory Array.
1.
System
Navigate to the
2.
context system
At the context prompt, type:
3.
set led-test start
Displaying the Status of the VIMM LEDs
Log into the Memory Array.
1.
System
Navigate to the
2.
context chassis board 0 slot <n>
VMA-series Memory Array Installation and Service Guide
context level. At the root prompt, type:
on
on
on
off
Power B
LEDs, which are controlled by the presence
context level. At the root prompt, type:
context level. At the root prompt, type:
Testing the LEDs
109