Checking The Configuration - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Procedure
Step 1 Enter the user view.
Step 2 Run:
patch configuration-synchronize
The patch is synchronized to the standby MPU.
After patch configurations and patch files are synchronized from the active MPU to the standby
MPU, the patch files, patch configurations, and patch status can remain unchanged if the active-
standby MPU switchover occurs.
----End

12.4.6 Checking the Configuration

After a patch is installed on the system, you can check the patch status and the patch for the next
startup.
Procedure
l
----End
Example
After the patch is loaded, run the
follows:
<HUAWEI> display patch-information
Service pack Version:V600R003C00SPH001
Pack file name
----------The patch information of slot
This slot does not need patch
----------The patch information of slot
This slot does not need patch
----------The patch information of slot
This slot does not need patch
----------The patch information of slot 33----------
Total Patch Unit
Running Patch Unit
Active Patch Unit
Deactive Patch Unit
----------The patch information of slot 34----------
Total Patch Unit
Running Patch Unit
Active Patch Unit
Deactive Patch Unit
<HUAWEI>display patch-information configure-file
Codes: M(Max patch ID in the board)
-------------------------------------------------------------
Issue 02 (2011-09-10)
Run:
display patch-information
Check the patch state.
cfcard:/patch.pat
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
display patch-information
3----------
4----------
6----------
: 1
:
:
: 1 - 1
: 1
:
:
: 1 - 1
12 Patch Management
command. The results are as
309