Example For Configuring Nap-Based Remote Deployment In Static Mode - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
None
Procedure
Step 1 Configuring the NAP master interface
# Do as follows on Router B.
<HUAWEI> system-view
[HUAWEI] sysname RouterB
[RouterB] interface gigabitethernet1/0/1
[RouterB-GigabitEthernet1/0/1] undo shutdown
[RouterB-GigabitEthernet1/0/1] nap port master
Step 2 Logging in to the slave device from the master device.
# Do as follows on Router B.
[RouterB-GigabitEthernet1/0/1] nap login neighbor
Trying 10.167.253.10 ...
Press CTRL+K to abort
Connected to 10.167.253.10 ...
Info: The max number of VTY users is 10, and the number
<HUAWEI>
Step 3 Shutting down NAP on the slave device.
# Do as follows on Router C.
<HUAWEI> system-view
[HUAWEI] sysname RouterC
[RouterC] undo nap slave enable
----End
Configuration Files
None
10.14.6 Example for Configuring NAP-based Remote Deployment
in Static Mode
In this example, the temporary neighbor relationship is set up between the router and the device
with the empty configuration and IP addresses are assigned to the router and the device to
implement remote deployment in manual mode.
Issue 02 (2011-09-10)
Configure a primary IP address and a secondary IP address on Router B.
Configure the NAP master interface on Router B.
Telnet to Router C from Router B by means of NAP.
of current VTY users on line is 1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Device Maintenance
293